Announcements

Over the button 'Setup RF Anouncements' on the main window one arrives at the following window, where the audio files and that can be registered interval for the ID's. The audio ID of entries in the distance to the adjusted interval time are spent in sequence, always. After the last entry again first follows. Sending ID's should be as reservedly as possible used, in order to strain the nerves of the other users not unnecessarily on the same channel.

Announcement Tick Time (Seconds) Preset Room 0...9 Message Connect Message Disconnect Message Disable Messag New Edit Delete Back

Announcement Tick Time (Seconds)

Here the time between two ID sending is entered. This time is always put back, if the server is active/gateway. Sending effected without consideration for the settings of the ID and is sent in each case, if the frequency were free at least the Tick Time.

Preset Room 0...9 Message

With the buttons 'Preset Room 0..9 Message' Wave files can be specified by the exchange via DTMF signals in other rooms, as receipt issued by radio.

Top

The Preset Rooms 0...9 are the same as under Preset Servers.
In the picture of Preset Rooms the Room 1 is configured to Server pmr-radio.net and Room ENGLISH. Therefor the Wave file for the Room 1 has to note the Room ENGLISH.

Connect Message

With the button 'Connect Message' a Wave files can be specified by the exchange via DTMF signals after the Gateway has bin connected to the server, as receipt issued by radio.

Disconnect Message

With the button 'Disconnect Message' a Wave files can be specified by the exchange via DTMF signals after the Gateway has bin disconnected from the server, as receipt issued by radio.

Disable Message

With the button 'Disable Message' a Wave files can be specified by the exchange via DTMF signals, if there was an error in the DTMF code.

New

Through click on 'New', the following window are opened.

Top
Example for WAV file

Top
Example for  Morse Announcement

 

Announce at Tick

The 'Announce at Tick' number is a sequential number on the basis those, which are sorted entries in the list. Also a later change causes a new assortment.

Generate Morse Announcement

If a checkmark is set here, in place of an audio file, that is spent in the main window under ID CW registered text as Morse code. An audio file cannot be selected then for this announcement.

Wave File

Here you can choose the Wave file, which is send under this ID number or put in the Morse text.

OK

With this button the new entry in the list is stored. 

Cancel

Over this button the new entry is rejected. 

 

Edit

The same window is opened as with 'New', in order to be able to make changes at an existing entry

Delete

With the left mouse button an entry mark (so that it is blue deposited) and then through click on the button deletion, the entry remove.

OK

With this button the entries of the announcements are stored.

Cancel

Over this button the changes are rejected.

 

Back