DTMF and RF Announcements

Setup RF Announcements Next Tick (1) in ... s DTMF DECODE Auto Return DTMF Help DTMF on

Setup RF Announcements

Over this button a new window opened where the Wave files for the RF announcement can be configured.

Next Tick (1) in ... s

Here you can see, how long it lasts still up to next sending of the RF announcement. Indication in seconds. 

DTMF DECODE

Here you can see the decoded DTMF touch tones for a short time.

Auto Return

With the two buttons 'On' und 'Off' you can choose, wether the Gateway will change back automaticly to the default room (room 0) after switching into an other room with DTMF touch tones without any activity. Right to the Off button you can see the actuell status (here ON).

DTMF Help

With this button you get a short help of the DTMF commands (see picture).

Back

DTMF on (Checkbox)

With this checkbox you can switch on the DTMF decoder or switch it off.

Connect Code

Connect Code Disconnect Code DTMF level control and display

Here, a DTMF code can be entered, with the help of the Admin the Gateway can be connectet via radio to the eQSO server. 12 is the standard code, you better change it.

Disconnect Code

Here, a DTMF code can be entered, with the help of the Admin the Gateway can be disconnectet via radio from the eQSO server. 21 is the standard code, you better change it.

DTMF level control and display

A DTMF mark consists of two audio frequencies. Using this control, the individual DTMF frequencies can setup, so that the Gateway correctly decode each character. Both too high and too low settings can cause a bad evaluation. About the controls for each frequency is a separate level display. Here is something to play until all the figures properly evaluated. Both too small and too large can lead errors by decoding.

The sound should be a half to one second, otherwise the program can not evaluate the tones. The pause between the tones should not be longer than one second, so that all tones are detected.

 

Back